2N IP series User Manual

Configuration manual for 2N IP intercoms
35 / 282
Event Description
LiftStatusCha
nged
Detection of Lift Control module connection/disconnection.
LoginBlocked Event generated after 3 wrong logins to the web interface. Contains
information about IP address.
MobKeyEnter
ed
Bluetooth authorization.
MotionDetect
ed
Generated after motion detection, settings can be made in Hardware /
Camera / Internal Camera.
NoiseDetecte
d
Generated after noise detection, settings in Hardware / Audio.
OutputChang
ed
Signalsa state change of the logic output.
RegistrationS
tateChanged
Change of the SIP Proxy registration state.
RexActivated Event at input activation set for the REX button.
SilentAlarm Silent alarm event generated whenever a code higher by one than the correct
one is entered. With access code 123, the silent alarm code is 124. Or,
whenever a finger is placed on the fingerprint reader module designated for
silent alarm activation.
SwitchesBloc
ked
Switches blocked by an invalid access attempt.
SwitchOperat
ionChanged
Switch operation changed (signals switch lock/hold, timer start/restart/
termination – transition to permanent hold).
SwitchStateC
hanged
Change of the switch state, settings in Hardware / Switches.
TamperSwitc
hActivated
Signals tamper switch activation – device cover opening. Make sure that the
tamper switch function is configured in the Digital Inputs | Tamper Switch
menu.
Unauthorized
DoorOpen
Unauthorized door opening indication, settings in Hardware / Door / Door.

2N IP series Specifications

General

Category	Intercom System
Network Interface	10/100 Mbps Ethernet
Connectivity	Ethernet
Integration	SIP
Ingress Protection	IP54
Operating Voltage	12V DC
Audio Codec	G.711
Supported Protocols	SIP, RTSP, HTTP, HTTPS
Supported Languages	Multiple