A
BOUT
T
HIS
G
UIDE
Introduction
This guide describes how to install the following 3Com
EtherLink
III Parallel Tasking
10 Mbps PCI bus master
network adapters:
■
3C590-COMBO (10BASE-T, thin coax, and thick coax) adapter
■
3C590-TPO (10BASE-T) adapter
Also included is information about installing network drivers,
troubleshooting the adapter, and using the diagnostic tests if
an adapter malfunction occurs.
Throughout this guide, the product number 3C590
designates the EtherLink III family of 10 Mbps PCI adapters.
How to Use This Guide
The following table shows where to find specific information
in this guide.
If you are looking for:
Turn to:
Information about the 3Com PCI bus master network adapters
and an introduction to PCI technology
Chapter 1
Instructions for installing the adapter Chapter 2
Procedures for connecting the adapter to the network Chapter 2
Instructions for installing network drivers Chapter 3
Details on troubleshooting and running the diagnostic tests Chapter 4
Procedures for changing software option settings Appendix A
Information on adapter specifications, pin assignments, and
cabling requirements
Appendix B
Information on 3Com’s technical support services Appendix C
To Next Page
Loading...
