Non-NetWare Environments 3-11
Driver Installation with NetWare 3.12
To install the 4.x server driver while running NetWare 3.12,
follow these steps:
1 Copy the contents of the appropriate \NETWARE subdirectory
to the boot partition of the server’s hard disk.
2 When you start the server, enter the following commands:
load C:3C59X.LAN PORT=XXXX NAME=X [Enter]
load C:3C59X.LAN PORT=XXXX NAME=Y [Enter]
where XXXX is the adapter’s port address and NAME X and Y
are names that you assign to help distinguish the multiple
adapters. (To determine the port address, refer to the
section “Finding the Adapter’s Port Address” earlier in this
chapter.)
If the load sequence above is not followed, the system will
not operate correctly. Make sure that the PORT=XXXX
parameter is completed for all adapters.
3 When this has been done, bind the protocol to the
user-assigned names.
Non-NetWare Environments
To install drivers in a non-NetWare environment, follow these
steps:
1 Access the main menu as described in the section
“Detailed Installation” earlier in this chapter.
2 Select Network Drivers in the main menu.
3 Select the appropriate driver for your network operating
system from the menu choices.
The menu program copies the selected driver to a specified
disk drive.
Refer to the on-line text files on the 3C59X EtherDisk diskette
for information about working in other network operating
systems. Refer also to the network operating system
manuals for additional information.
To Next Page
Loading...
