1
Installation Instructions
Cross-Lane Module
78-6911-4396-6
Description: The Cross-Lane Module allows two base stations in a dual-lane configuration to be operated by a
single headset, using the dual-lane remote switch. A headset with a Dual-Lane Remote Switch can communicate
with either base station in a cross-lane installation via the lane select switch. The Cross-Lane Module allows the
headset to receive the vehicle alert tone and audio from a base station that the lane select switch is not set to.
Additional Material Required:
D
A sufficient length of six-conductor 20 AWG twisted pair audio cable (not supplied) for connecting the
Cross-Lane Module to the two base stations.
D
Applicable screws/fasteners (not supplied) for mounting the Cross-Lane Module.
Installation:
1. Use the applicable screws/fasteners and mount the Cross-Lane Module to the wall in a convenient location
next to one of the base stations.
Note
To ensure access to the switch on the Cross-Lane Module, locate the module near one of the
base stations.
2. Run the proper length of six-conductor 20 AWG twisted pair audio cable between the Cross-Lane Module
and the nearest base station.
3. Run the proper length of six-conductor 20 AWG twisted pair audio cable between the Cross-Lane Module
and the other base station.
Important!
For proper operation, the base stations must be at least 15 feet apart.
4. Remove the half-cover from each base station by slightly pulling out on the lower right side of the cover and
then lifting it off.
To Next Page
Loading...
