User’s Manual
WHG Controller / HSG Gateway ENGLISH
Select any AP by checking the checkbox and then click the button below to Reboot, Enable, Disable,
Delete, Apply Template and Apply Service Zone (Tag-Based) the selected AP if desired.
b) List
A list is used to show the information of each managed AP, including Type, Name, IP Address, MAC
Address, and online Status. Functions in this section also include the operations such as reboot, enable,
disable, delete, apply a new template, and other configuration.
All of the supported APs under management of the system will be shown in the list. In the beginning, the
list is empty. The administrator can add supported APs from Discovery or Adding tabs. After APs are
added, this list will show the current managed APs including AP type, AP name, IP Address, MAC
Address, Service Zone and Status. The administrator can reboot, enable, disable, delete the managed
APs, or apply template or apply service zone to them by checking the check box in front of each individual
AP or selecting all the APs together by checking the top check box.
To Next Page
Loading...
