User’s Manual
WHG Controller / HSG Gateway ENGLISH
The prefix of IPv6 address
When Auto-Negotiation is On, the System chooses the highest performance
transmission mode (speed/duplex/flow control) that both the system and the
device connected to the interface support.
Displays current speed and duplex of the selected interface.
Displays daily, monthly and all time graphical summary of the TX and Rx rate
for this interface.
Displays traffic information of the day in a table.
Displays traffic information of the in a table.
Shows the top 10 traffic of the day records.
Service Zone –
Default,
SZ1~SZ8
The operation mode of the SZ.
The MAC address of the SZ.
The IP address of the SZ.
The Subnet Mask of the SZ.
The IPv6 address of the SZ
Service Zone –
DHCP Scope
(Default,
SZ1~SZ8)
Enable/disable stands for status of the DHCP server in Default Service Zone
The WINS server IP on DHCP server. N/A means that it is not configured.
The start IP address of the DHCP IP range.
The end IP address of the DHCP IP range.
Minutes of the lease time of the IP address.
3) Monitor Users
All online users/devices will be listed here. The administrator can terminate any user session by clicking
the Kick Out button. Non-login users will be listed here as well.
Online Users: Successfully authenticated Local Users.
Cross Gateway Roaming In User: Roaming Users authenticated at roaming peer controllers.
On-Demand Roaming Out User: On-Demand users authenticated at external controllers via
RADIUS protocol.
Non-Login Local User: Obtained IP address but has not yet authenticated Local Users.
MAC Login Devices: Disconnected MAC authenticated devices need not be re-plugged
physically, and can be MAC authenticated on the MAC Login Devices List