User’s Manual
WHG Controller / HSG Gateway ENGLISH
1. DHCP Server Configuration – The default setting for DHCP Server is “Enable”.
Select other options from the drop-down list.
2. Define the IP range for issuing when using Enable DHCP Server (built-in). There
are a total of six DHCP pools for configuration.
3. Reserving IP addresses – A configuration list for reserving certain IP’s within the
DHCP Server IP range for specific devices, for example an internal file server.
4. DHCP lease protection – This is an optional checking mechanism on the
Controller when Enabled, will check to see if the lease expired IP is currently
online. If yes, the Controller will halt the issuing of this IP address until the user
session terminates.
5. Click “Apply” to activate changes.
6.2.5. Authentication Options
Configuration Path: Main Menu >> System >> Service Zones >> Configure
Once the administrator has properly configured the authentication servers under
the Main Menu, each Service Zone can select the authentication option preferred to
downstream clients for login. Note that Authentication is always enabled by default.
1. Databases
Administrator can designate configured auth servers for use. Postfix will be used as
To Next Page
Loading...
