User’s Manual
WHG Controller / HSG Gateway ENGLISH
VLAN Isolation, Clients Isolation, and None.
o Inter-VLAN Isolation: 2 clients within the same VLAN will not see each other
when coming in from different ports. Note that Isolation is done when traffic
passes through the gateway. When a switch or AP is being deployed, Station
Isolation has to be enabled on the AP/switch.
o Clients Isolation: All clients on the same Layer 2 network are isolated from
one another in this Service Zone.
o None: No isolation will be applied to clients in this Service Zone.
Note that when “None” is selected, a switch port connecting to the LAN port of the
WHG may be shut down if the switch has loop protection enabled and there are
more than 2 VLANs belong to one Service Zone.
6.2.4. DHCP Server options
Configuration Path: Main Menu >> System >> Service Zones >> Configure
Dynamic Host Configuration Protocol (DHCP) is a network protocol that enables a
server to automatically assign an IP address to a computer from a defined range of
numbers (i.e., a scope) configured for a given network. 4ipnet WHG Controllers
supports independent DHCP settings for each Service Zone profile. Options include
Disable DHCP option, Enable built-in DHCP server or DHCP Relay.
To Next Page
Loading...
