33
FAULT OCCURRENCE MENU
Fault Occurrence Menu
ACTION DISPLAY
Total accumulated number each individual Fault condition has occurred
is displayed in this menu. This running total of Fault Occurrences can
be useful in determining which (if any) operational problems have been
persistent.
This control system menu allows the user to restore most of the control
system’s user settings to their factory default settings. User settings in the
Alarm Output Setup and Display Settings menus are unaected by execut-
ing Restore Factory Defaults.
RESTORE FACTORY DEFAULTS MENU
This control system menu allows the user to restore most of the control system’s user settings to their factory default settings. User
settings in the Alarm Output Setup and Display Settings menus are unaected by executing Restore Factory Defaults.
Table 16. Restore Factory Defaults
ACTION DISPLAY
From the Main Menu use the Up/Down buttons to select (highlight in
black) the “Restore Factory Defaults” menu.
Press the Operational Button underneath “SELECT.” The Restore Fac-
tory Defaults menu will be displayed.
From the Restore Factory Defaults menu press the Operational Button
underneath “YES.” The display will show text conrming the factory
default settings have been restored.
Press the Operational Button underneath “BACK” to exit the Restore
Factory Defaults menu.
The following pages are for Installation, Service/Maintenance and Troubleshooting.
These instructions are to be used and performed by a Qualied Installer or Service Agency only.
Printed on 5/6/2022 7:17 AM CT