Supplementary features
Aastra 632d 67
eud-1586/1.0 – R3.0 – 04.2013
Activating ring alone
You wan to specify which of your phone shall ring when you receive a call.
When your system administrator has set up a phone number with several phones
(One-number user concept, see chapter "Purpose and function", page 8), you can
define on which phones a call shall acoustically be signalled using ring alone.
When you have activated ring alone on a phone, the acoustic ringing tone is deacti-
vated for all other phones ( ). An incoming call is signalled in the display of all
phones. You can answer the call on each of your phones.
This function must be stored under a function key (see chapter "Configuring keys",
page 102).
Activating / deactivating room monitoring (Baby surveillance)
You want to use your cordless phone to observe acoustic monitoring tasks, for exam-
ple to monitor a toddler.
You can activate a room monitoring mode on your cordless phone. You can select
between active and passive room monitoring.
Activate the room monitoring on your cordless phone ( is displayed). The micro-
phone for room monitoring is activated after a delay of 10, 20 or 30 seconds. Use this
time lag to position the cordless phone in the room where you want e.g.to monitor
your child and leave the room.
Active room monitoring:
As soon as the ambient noise level near the monitoring phone exceeds the config-
ured level (noise sensitivity Very low, Low, Medium, High) or more than 2 seconds, a call
is immediately triggered to an internal or external destination number you have spec-
ified (destination phone). is displayed.
Note:
When you have activated ring alone but deactivated the personal call routing for a
phone in parallel, an incoming call is not acoustically but only visually signalled.
Ring alone
In the idle state:
Press the function key for Ring alone.
➔Ring alone is activated/deactivated.
www.InternetVoipPhone.co.uk | sales@internetvoipphone.co.uk | 0800 088 48 46
To Next Page
Loading...
