Supplementary features
Aastra 632d 77
eud-1586/1.0 – R3.0 – 04.2013
Setting functions by remote control
This section explains how you can alter your phone’s settings even if you are not
directly at your phone.
You are not at your desk and want to set various functions on your phone from a dif-
ferent phone.
You can activate/deactivate many of your phone's functions by remote control from a
different phone.
The remote control is initiated using a special function code. You can then enter the
function commands and function codes.
<Function code>
Using remote control from a third-party phone:
1. Enter function code #06.
2. Enter your phone number.
3. Enter your PIN.
4. Enter the function code for activating/deactivating the function you want.
Press the Call key.
➔Acknowledgement tone sounds; function is activated/deactivated.
Note:
The default PIN setting "0000" is not accepted. First change the PIN as
described in chapter "Changing the User PIN", page 91 or use the function
code *47 (see "User’s Guide Function Codes" on the Aastra DocFinder). If you
have forgotten your PIN, your system administrator can reset it to the default
setting.
www.InternetVoipPhone.co.uk | sales@internetvoipphone.co.uk | 0800 088 48 46
To Next Page
Loading...
Need help?
General
