6/1553-DBC 434 01 Uen C 2010-12-17 34
S
TARTING THE PHONE
5. If a new software version is available, you will be notified via a
display message.
3.1.2 Logging On To the System
When the phone is logged on to the network, there are three possible
scenarios:
• The phone is ready to use. This means that the phone logs on auto-
matically to the telephony system.
• You have to log on the phone to the telephony system with an
extension number.
• You have to log on the phone to the telephony system with both an
extension number and password (or PIN code).
Note: The PIN code can be changed by the user (see 13.8.1 Changing
PIN Code on page 102), whereas the password can only be set
by the system administrator.
If you are required to log on the phone to the telephony system, you are
prompted to enter your extension number, or your password (or PIN
code), or both.
To log on to the telephony system, do the following:
1. Enter your extension number and press Log on
2. Enter the password (or PIN code), if required, and press Log on
again.
Note: If the extension number or password is not accepted, the
following message is displayed: “Failed User Log on! No calls!”
Then make a new logon attempt. Should the logon fail again,
please contact the system administrator.
The phone does not work during power failure. After a power failure the
phone automatically restarts. When the phone is starting up (rebooting),
any PC that is connected to the phone will loose its network connection
for about 10 seconds.
To Next Page
Loading...
