23Dialog 4422 IP Office
Start the Phone – Log On/Off
Update software
If new software has to be loaded into your phone, the display is
showing this. When new application software is available, the
following display is shown:
The x indicates a timer counting down from 60 seconds. If no key
is pressed during this time, “Yes” is selected automatically.
Note: You can speed up the procedure by pressing the
Speaker key.
Press to update the software (=Yes).
The software is loaded from the server. This takes about
60 seconds. The phone is then ready for use or ready for log on. To
log on, see section “Log on” on page 24.
Note: It is important that you do not disconnect the power
to the phone while the new software is being downloaded
and saved. If a power failure occurs, the software must be
downloaded again.
If you want to continue to use the previously stored setting:
Press to use the current version of the software (=No).
A new application version
is available, update? (x)
To Next Page
Loading...
