27Dialog 4422 IP Office
Start the Phone – Log On/Off
Entering letters and numbers
You can see the most common letters above each key on the
phone. To get the letter A press key 2 once, for B press key 2
twice, to get C press key 2 three times, and so on.
Note: If the word to enter contains a digit, the digit can be
created by pressing the digit key for more than 1 second.
By default, the first character you enter is written in upper case,
and the rest of the word is written in lower case. Every new word
starts with an upper case character (that is after a space has been
entered). However, you can force the phone to enter all characters
as upper case only, or lower case only, see below.
* Press to switch between upper and lower case.
All entered characters are entered as upper or lower case. This is
only valid for the characters A-Z.
ì
Press (-) to correct a wrong entry.
For the Dialog 4422 v. 2 phone, a square is shown around the
available characters. If you for example press
9, the following
character options are shown on the display:
Press 9
A new character (w, x, y, z or 9) is selected each time you press the
key.
To Next Page
Loading...
