Alarm
Aastra 630d 65
eud-1095/1.0 – I7.8 – 07.2009
■ Response times
You can set the following response times (hh:mm:ss):
• Detection duration
• Sensitivity
• Alarm cancellation delay
• Alarm confirmation time
As soon as the phone detects an alarm situation, the Detection duration starts to run. An alarm is
only triggered when the detection duration has completely expired and the alarm status has
constantly occurred during this time. You can set a different duration for each alarm:
• The detection duration for man-down and no-movement alarm: min. 00:00:10 up to
max. 23:59:59.
• The detection duration for escape alarm: min. 00:00:05 up to max. 00:00:59.
For no-movement and escape alarm you can also set the Sensitivity (High, Medium, Low) of the
detection.
The Alarm cancellation delay indicates the pre-alarm’s duration as of when the alarm is to trig-
ger. You set the duration for all alarms together: min. 00:00:00 up to max. 00:59:59.
The Alarm confirmation time indicates how long the alarm shall ring as long as the receipt is not
acknowledged on the phone. You set the duration for all alarms together: min. 00:00:00 up to
max. 23:59:59.
If the alarm settings are protected by the Admin PIN (see chapter "Locking the alarm settings",
page 70) you will be prompted for it before you can make the first change. After you have
entered the correct Admin PIN, all the alarm settings are freely accessible until you return to the
idle state.
■ Stopping a triggered pre-alarm
The man-down, no-movement and escape alarm has been triggered and you now want to stop
it.
You can stop the alarm on the phone as long as no alarm message has been sent to the alarm
system. Whether you can still stop the alarm thereafter depends on the alarming concept set.
Cancel
No-movement, man-down and escape alarm was triggered:
Press the Cancel softkey or any key.
➔ The pre-alarm on the phone is stopped.
eud-1095_en.book Page 65 Monday, July 13, 2009 1:56 PM
To Next Page
Loading...
Need help?
General
