Alarm
Aastra 630d 69
eud-1095/1.0 – I7.8 – 07.2009
Setting the alarm signalling
You want to adapt the way in which your phone signals pre-alarms and alarms.
When the phone triggers an alarm, a pre-alarm sounds locally on the phone, after that the
phone sends an alarm message to the alarm system. The alarm is then subsequently processed
by the alarm system. The alarm system can be set up so that the alarms are also signalled on the
phone.
You can add the vibracall to the pre-alarm melody.
■ Setting the pre-alarm signalling
The phone provides a selection of pre-alarm melodies.
■ Setting the server alarm signalling
When the server alarms are activated in the system, you can select from the alarm signalling as
follows: Vibracall, Progressive ring tone, Suppress ring tone (see chapter "Setting the server
alarm", page 46).
Press the navigation key to the right or the Menu softkey.
Settings
Scroll to Settings and press the Select softkey.
Sensor alarm
Scroll to Sensor alarm and press the Select softkey.
Alarm melody
Selecting the pre-alarm melody:
1. Scroll to Alarm melody and press the Select softkey.
2. Scroll to the setting you want and confirm your choice of setting with the
Select softkey.
➔ The setting is stored.
Note:
To listen to all the melodies use the Te st softkey.
Vibracall
Selecting the vibracall:
Scroll to Vibracall and press the Select softkey.
➔ The setting is stored.
eud-1095_en.book Page 69 Monday, July 13, 2009 1:56 PM
To Next Page
Loading...
Need help?
General
