261Gx, 261Ax | IM/261Gx/Ax-EN Rev. 08 7
1.8 Compliance with Pressure Equipment Directive
(2014/68/EU)
Devices with PS > 200 bar (20 MPa)
Devices with a permissible pressure of PS > 200 bar (20 MPa)
have been tested for conformity by the Technical Supervisory
Association TÜV NORD (0045) in accordance with module H
and can be used for fluids of group 1 (PED: 1G).
The name plate bears the following identification codes:
Fig. 3: Identification codes according to Pressure Equipment
Directive (example)
1 PED: 1G | 2 Identification number of the notified body according
to the Pressure Equipment Directive | 3 "SIL 2" identification code
(optional)
Devices with PS ≤ 200 bar (20 MPa)
Devices with a permissible pressure PS ≤ 200 bar (20 MPa)
conform to sec. 3 para. (3) and have not been tested for
conformity. The devices have been constructed and
manufactured according to sound engineering practice (SEP).
The CE marking on the device does not refer to the Pressure
Equipment Directive.
The name plate then contains the following identification
codes: PED: SEP.
1.9 Transport safety instructions
Observe the following instructions:
— Do not expose the device to humidity during transport.
Pack the device accordingly.
— Pack the device so that it is protected against vibrations
during transport, e.g., by using air-cushioned packaging.
Prior to installation, check the devices for possible damage
that may have occurred as a result of improper transport.
Details of any damage that has occurred in transit must be
recorded on the transport documents. All claims for damages
must be submitted to the shipper without delay and before
installation.
1.10 Storage conditions
— The device must be stored in dry and dust-free conditions.
Always keep the device in its original package during
storage / transport.
— Observe the permissible ambient conditions for transport
and storage according to the chapter “Technical Data”.
— In principle, the devices may be stored for an unlimited
period. However, the warranty conditions stipulated in the
order confirmation of the supplier apply.
1.11 Safety instructions for electrical installation
The electrical connection may only be established by
authorized specialist personnel and in accordance with the
connection diagrams.
The electrical connection information in this manual must be
observed; otherwise, the IP rating may be adversely affected.
Ground the measurement system according to requirements.
1.12 Safety instructions for operation
Before switching on the device, make sure that your
installation complies with the environmental conditions listed in
the chapter “Technical Data” or on the data sheet.
If there is a chance that safe operation is no longer possible,
take the device out of operation and secure it against
unintended startup.
1.13 Returning devices
Use the original packaging or a secure transport container of
an appropriate type if you need to return the device for repair
or recalibration purposes. Fill out the return form (see the
Appendix) and include this with the device.
According to the EU Directive governing hazardous materials,
the owner of hazardous waste is responsible for its disposal or
must observe the following regulations for shipping purposes:
All devices delivered to ABB must be free from any hazardous
materials (acids, alkalis, solvents, etc.).
Please contact Customer Center Service acc. to page 2 for
nearest service location.
To Next Page
Loading...
