Operation Manual / 4 Product description / A130-M.. - A145-M..
8 Dismantling and fitting / 8.15 Installing the cartridge group
© Copyright 2020 ABB. All rights reserved. HZTL4031_EN Rev.L July 2020
8.15 Installing the cartridge group
Lifting the cartridge group and rotating it by 90°
Fig.50: Lifting the cartridge group and rotating it by 90°
1. Loosen and remove nuts.
2. Lift the cartridge group out of the service support(90012).
3. Insert the screws of the service support from above and fit ring nuts(VRM) with washers.
4. Attach lifting gear to the ring nuts(VRM).
5. Lift cartridge group at the side of the ring nuts(VRM) and turn it into a vertical position.
Installing the cartridge group
Fig.51: Installing the cartridge group
Page 86 / 114
To Next Page
Loading...