4.1.5 Editing values
1. Select a menu in the menu navigation bar.
2. Click a submenu to see the function blocks.
3. Click a function block to see the setting values.
4. Click Enable Edit.
5. Edit the value.
• The minimum, maximum and step values for a parameter are shown in the
Min., Max. and Step columns.
Figure 14: Editing a value
• If the entered value is out of range, the row is highlighted in red and a
warning messages displayed. Write to device is available, but the write and
commit confirmation is not allowed.
IED operation
1MRS758850 D
34 SSC600
Operation Manual
To Next Page
Loading...
