4.1.7 Clearing and acknowledging
Reset, acknowledge, or clear all messages and indications, including LEDs and
latched outputs as well as registers and recordings, in the Clear menu.
1. Select Clear from the main menu structure.
Figure 17: Selecting clear menu
2. Set the New Value to Clear for those items to be cleared.
3. Select Write to device to save the changes.
4.1.8 Web HMI views
The different views available in the WHMI are illustrated below. Use the View bar to
access different views.
Figure 18: View bar
• Dashboard contains a quick snapshot of the system state.
• Single Line Diagram view shows the single-line diagram.
• Alarms view shows the status of the programmable virtual LEDs.
• Network configuration (only available in the SSC600 SW) shows an editable list
of device network interfaces.
• About page shows brief information about the device.
• Measurements page shows phasor diagrams.
1MRS758850 D
IED operation
SSC600
Operation Manual
37
To Next Page
Loading...
