USER’S MANUAL
18/26
CE Declaration of Conformity
CE marking
A CE mark is attached to the drive to verify that the drive follows the provisions of the
European Low Voltage, EMC, RoHS and WEEE Directives. The CE marking also
verifies that the drive, in regard to its safety functions (such as Safe torque off),
conforms with the Machinery Directive as a safety component.
Compliance with the European Low Voltage Directive
The compliance with the European Low Voltage Directive has been verified according to standard EN
61800-5-1:2007.
Compliance with the European EMC Directive
The EMC Directive defines the requirements for immunity and emissions of electrical
equipment used within the European Union. The EMC product standard (EN 61800-
3:2004 + A1:2012) covers requirements stated for drives.
Compliance with the European ROHS Directive 2011/65/EU
The RoHS Directive defines the restriction of the use of certain hazardous
substances in electrical and electronic equipment.
Compliance with the European WEEE Directive 2002/96/EC
The WEEE Directive defines the regulated disposal and recycling of electric and
electrical equipment.
Compliance with the European Machinery Directive
2006/42/EC 2nd Edition – June 2010
The drive is a machinery component that can be integrated into a wide range of
machinery categories as specified in European Commission’s
Guide to application of
the Machinery Directive 2006/42/EC 2nd Edition – June 2010
.
To Next Page
Loading...
