USER’S MANUAL
12/26
Commissioning
First start assistant
To commission the drive, step through the First start assistant. Note that the nominal values must be
set according to the type label of the motor. In case of a problem, the instructions for First start assis-
tant can be found in the ACH580-01 quick installation and start-up guide delivered with the democase.
The nominal values of the motor are presented in the rightmost column in the table.
The First start assistant does not occur
If the drive has already been commissioned (i.e. First start assistant does not occur when switching on
the demo) check that the motor nameplate parameters are set according the motor. The parameters can
be checked from
Parameters modified
. First start assistant can also be redone from
Primary settings
Advanced functions First start assistant.
Nominal values are correct but the drive does not function properly
In case the nominal values are correct and the drive does not function as desired, one can always restore
the factory settings from
Primary settings Reset defaults Reset all to factory defaults
After this, the drive will start the First start assistant from the beginning.
To Next Page
Loading...
