38 ACS 300 User’s Manual
Chapter 6 - Control and Parameter Logic
Figure 6-1 ACS 300 Control Panel.
Blinking Indicates Setting
Mode after pressing
REMOTE LED lights
when drive is under I/O
(remote) control. LED is
off when drive is under
panel (local) control.
FAULT LED lights if a fault
has occurred in the drive.
DIRECTION LEDs light to indicate the
direction the motor is running or will run
when started. LED blinks slowly if drive
is stopped. LED blinks fast when the
drive is changing direction.
DECREMENT &
INCREMENT keys, used
for scrolling through
parameter lists and
setting parameter values.
MODE key, used to
toggle between
parameter scrolling and
setting.
START/STOP key, used
to toggle motor on and
off.
DIRECTION key, used
to select the motor
rotation direction. LEDs
indicate selected
direction.
Parameter name Parameter value
REMOTE key, toggles between wired
and panel control. Key must be
pressed for three seconds to change
from remote to local control. Back to
remote control you get by pressing
Remote key.
To Next Page
Loading...
