￭
To install the drive to a DIN installation rail for frame sizes R3 and R4
Use an IEC/EN 60715 top hat type installation rail, width × height = 35 × 7.5 mm
(1.4 × 0.3 in).
1. Move the locking part to the left.
2. Push and hold the locking button down.
3. Put the top tabs of the drive onto the top edge of the DIN installation rail.
4. Put the drive against the bottom edge of the DIN installation rail.
5. Release the locking button.
6. Move the locking part to the right.
7. Make sure that the drive is correctly installed.
To move the drive, use a flat-head screwdriver to open the locking part.
42 Mechanical installation
To Next Page
Loading...
