ControlMaster CM30 and CM50
Universal process controllers,
1
/4 and
1
/2 DIN 7 Advanced Level
IM/CM/ED–EN Rev. B 29
…Display
Date & Time Sets the date format, local time / date and daylight saving start / end times.
Date Format Selected from: DD–MM–YYYY, MM–DD–YYYY, YYYY–MM–DD.
Time & Date Sets the controller’s time and date.
Daylight Saving Sets daylight saving parameters.
DS Region
Off
Daylight saving is disabled.
Europe
Standard daylight saving start and end times are selected for Europe automatically.
USA
Standard daylight saving start and end times are selected for USA automatically.
Custom
Used to create custom daylight saving start and end times manually for regions other
than Europe or USA.
Note. Enables Daylight Start Time and Daylight End Time parameters.
DS Start Time The start time selected from 1-hour increments.
Note. Displayed only when the DS Region sub-parameter is Custom.
DS Start Occur
DS End Occur
The day within the month that daylight starts / ends – for example, to set daylight
saving to start (or end) on the second Monday of the selected month, select Second.
DS Start Day
DS End Day
The day of the month daylight saving starts / ends.
Note. The Daylight Start / End Occur parameters must be valid within the month for
the selected day.
DS Start Month
DS End Month
The month daylight saving starts / ends.
To Next Page
Loading...
