ControlMaster CM15 and CMF160
Universal process indicator
1
/8 DIN 1 Safety
IM/CM/I–EN Rev. P 3
1Safety
Information in this manual is intended only to assist our customers in the efficient operation of our equipment.
Use of this manual for any other purpose is specifically prohibited and its contents are not to be reproduced in full
or part without prior approval of the Technical Publications Department.
1.1 Electrical Safety
This equipment complies with the requirements of CEI / IEC 61010-1:2010 3
rd
edition 'Safety Requirements for Electrical
Equipment for Measurement, Control and Laboratory Use' and complies with US NEC 500, NIST and OSHA.
If the equipment is used in a manner NOT specified by the Company, the protection provided by the equipment may
be impaired.
1.2 Symbols
One or more of the following symbols may appear on the equipment labelling:
Warning – Refer to the manual for instructions Direct current supply only
Caution – Risk of electric shock Alternating current supply only
Functional earth (ground) terminal Both direct and alternating current supply
Protective earth (ground) terminal The equipment is protected through double insulation
To Next Page
Loading...
Need help?
General
