102 Technical data
EtherCAT link
Mounting Into the option slot on the drive
Degree of protection IP20
Ambient conditions The applicable ambient conditions specified for the
drive in its manuals are in effect.
Indicators Two green LEDs and one bicolor LED: LINK/ACT,
LINK/ACT and STATUS
Connectors 20-pin connector to the drive (X3)
Two 8P8C modular jacks (X1 and X2)
Power supply +3.3 V +
5% max. 450 mA (supplied by the drive)
General Complies with EMC standard EN 61800-3:2004
Printed circuit board conformal coated
Compatible devices All EtherCAT-compliant devices
Medium 100BASE-TX
• Termination: Internal
• Wiring: Cat 5e FTP
1)
or STP
1)
(UTP)
• Connector: 8P8C modular jack (RJ-45)
• Maximum segment length: 100 m
Topology Daisy chain
Transfer rate 100 Mbit/s
Serial communication
type
Full duplex
Protocol EtherCAT
1)
Shielded cable strongly recommended
To Next Page
Loading...
