2CDC172114M0201 13 www.abb.com/lowvoltage
2019-09-06 V1.3
Connection with AS-i Network
Fixed connection
In this version, the connection is achieved using a two-core cable. The enabling device is delivered with this
already firmly attached. This version of connection is particularly recommended if a configuration of the
enabling device with an integrated emergency stop button is being used.
Note on the connection cable!
If the enabling device is connected using a spiral cable and more than three HD5-B-xxx are used on an AS-i
cable, you must reduce the AS-i cable by 12m per device
Attention!
Please note, if an emergency stop button is implemented in the enabling device and the connection
becomes deconnected, additional measures can required, as described in
Section 3 “Functional description, emergency stop button”.
To Next Page
Loading...
