To Next Page

To Previous Page

Operation Manual / 4 Product description / A150-M56/66/57/67 -

A155-M..

3 Commissioning / 3.2 Inspection procedures

3.2 Inspection procedures

3.2.1 Introduction

Inspection procedures include preventative visual controls, monitoring and measuring work

before and during commissioning. Inspection procedures enable changes to the turbochar-

ger to be detected. Machine damage can be prevented.

3.2.2 Checks before commissioning

Filter mat (if available)

u Check for damage and contamination.

Lubricating system

CAUTION

Contaminated oil

Serious damage to engine or property can be caused by dirt and solid ma-

terial particles in the oil.

u For the initial commissioning phase and after all service work, flush the

complete lubricating system with warm oil.

u Use special running-in filters when running in the engine and after all ser-

vice work on the lubricating system.

u Check that the oil filter is clean before commissioning.

u Check the oil pressure in the oil supply pipes.

Warning plates

u Check whether warning plates are present and legible.

u Check whether the protective sheets have been removed from new warning plates.

Version with compressor wheel cooling:

CAUTION

Failure of compressor wheel cooling

Any prolonged failure of the compressor wheel cooling will shorten the re-

placement interval of the compressor wheel.

u Make sure there is an uninterrupted supply of cooling air during opera-

tion.

u Check whether the compressor wheel cooling is fitted on the bearing casing.

Page 22 / 171

ABB HT611036 Instruction Manual

Other manuals for ABB HT611036