ABB IMASI13 - Page 125

Index (continued)
Index - 2 WBPEEUI240766B0
Functional operation
I/O expander bus....................................2-4
I/O expander bus interface.....................2-5
Input multiplexer (MUX) .........................2-3
LED indicators........................................2-4
Microcontroller and memory...................2-3
Switch settings .......................................2-3
Termination units....................................2-5
G
Gain and offset adjustment .......................2-8
Glossary of terms and abbreviations.........1-5
H
Halt - Display Error....................................6-5
I
I/O expander bus ......................................2-4
Bus interface ..........................................2-5
Communication security.......................2-10
IMASI13
Functional operation...............................2-1
Installation ..............................................3-2
Logic power ..........................................2-11
Operating procedures .....................5-1, 6-1
Operation ...............................................5-1
Overview ................................................1-1
Setup......................................................3-2
Startup....................................................5-1
Status LEDs ...........................................5-1
Troubleshooting .....................................6-1
Input
Calibration.......................................2-7, 4-3
Channel data..........................................6-2
Configuration..........................................4-1
Processing .............................................2-6
Input multiplexer (MUX) ............................2-3
Instruction
Content...................................................1-3
Glossary of terms and abbreviations ..... 1-5
How to use............................................. 1-4
Intended user......................................... 1-1
J
Jumper
Channel ................................................. 3-4
Configuration ......................................... 3-4
Location ................................................. 3-4
L
Logic power ............................................ 2-11
M
Maintenance ............................................. 7-1
Schedule................................................ 7-1
Tools required........................................ 7-2
Memory..................................................... 2-3
Microcontroller .......................................... 2-3
Module
Description............................................. 2-1
Installation ............................................. 3-2
Jumpers................................................. 3-4
Repair and replacement ........................ 8-1
Setup ..................................................... 3-2
Wiring .................................................... 3-6
Module functional tests
Continue - Do Not Display Error ............ 6-6
Halt-Display Error .................................. 6-5
Module functional test............................ 6-5
Test equipment required........................ 6-5
Module mounting unit ............................. 2-11
N
Nomenclatures ......................................... 1-6
NTAI06 termination unit
Cold junction reference input................. A-1
Configuring inputs..................................A-1