ABB IMASI13 - Page 126

Index (continued)
WBPEEUI240766B0 Index - 3
O
Offset and gain adjustment....................... 2-8
Onboard indicators .....................2-4, 5-1, 6-1
Online configuration................................ 2-11
Open input detection ....................... 1-3, 2-10
Operating modes ...................................... 6-6
Operating procedures ........................ 5-1, 6-1
Operation .................................................. 5-1
P
P1, P2, P3 connectors.............................. 3-6
PCB cleaning............................................ 7-3
Point value calculation.............................. 2-7
Power, logic ............................................ 2-11
Preventive maintenance
Checking connections............................ 7-4
Schedule................................................ 7-1
Tools and equipment ............................. 7-2
Processing I/O inputs ............................... 2-6
R
Reference documents .............................. 1-5
Repair and replacement ........................... 8-1
Restoring factory calibration ..................... 4-4
RTD types................................................. 1-2
S
S1 address switch
Settings.................................................. 3-3
Settings and error codes........................ 6-6
Security and integrity checks
Alarm and exception reporting............. 2-10
Diagnostics during normal operation ... 2-10
Diagnostics in diagnostic mode ............. 2-9
Diagnostics on reset ............................ 2-10
I/O expander bus ................................. 2-10
Open input detection ............................2-10
Select address ..........................................3-3
Setup and installation
Address switch (S1) ...............................3-3
Binary address .......................................3-3
Configuring inputs ..................................3-4
Jumper configuration..............................3-4
Jumper location ......................................3-4
Jumpers used for each channel .............3-4
Physical installation................................3-6
Termination unit configuration................3-5
Special handling........................................3-1
Specifications ............................................1-6
Startup.......................................................5-1
Switch settings ..........................................2-3
T
Termination ...............................................2-5
Cable connections..................................3-7
Unit.........................................................3-5
Test equipment required ...........................6-5
Thermocouples .......................... 1-2, 1-3, 2-7
Troubleshooting ........................................6-1
Onboard indicators.................................2-4
S1 settings and error codes ...................6-6
U
Unpacking and inspection.........................3-2
User gain and offset..................................2-8
W
Wiring connections and cabling ................3-7
Cable connections..................................3-7
Description .............................................3-6
P1, P2, P3 ..............................................3-6