32 36KV I
S
LIMITER PANEL INSTALLATION, OPERATION AND MAINTENANCE MANUAL
36Kv I
S
-limiter
TM
switchgears are produced in
compliance with the requirements of
international standards for quality management
system and environmental management system.
The level of excellence achieved in these fields is
documented by quality certificates according to
ISO 9001 and by the EMS according to ISO 14001.
End of life of product.
- The ABB company is committed to complying
with the relevant legal and other requirements
for environment protection according to the
ISO 140001 standard.
- The duty of the company is to facilitate
subsequent recycling or disposal at the end of
product life.
- During disposal of product, it is always
necessary to act in according with local legal
requirements in force.
The following methods of disposal are possible:
- Disposal can either be carried out thermally
in an incineration plant or by storing on a
waste site.
Raw material
material
Recommended
method of disposal
Metal material
(Fe, Cu, Al, Ag, Zn, W, others)
Separation and
recycling
Thermoplastics Recycling or disposal
Epoxy resin Separation of metal
material and the
disposal of rest
Rubber Disposal
Packing material - wood Recycling or disposal
Packing material - foil Recycling or disposal
CAUTION!
Disposal of I
S
-limiter
TM
inserts must
be carried out only by ABB Calor
Emag (Producer of this equipment).
Inside the I
S
-limiter
TM
inserts a small
charge is installed (figure 3.7). For
safety reason, it is strictly forbidden
to open this I
S
-limiter
TM
insert or to
take out the charge.
—
8. Disposal
To Next Page
Loading...
