ABB KPM KB2 - Settings and Variables

36
Appendix 5: Settings and variables
Parameters:
Mode: Detect Enabled or Maintenance
Light source: RGB or IR
Selected signal:
Detect limit:
Direction: Break < Det.Limit or Break > Det. Limit
Alarm signal:
Low alarm limit:
High alarm limit:
Drift Alarm:
Drift Alarm limit:
Drift Alarm direction:
Configuration
Autolimit&Autoalarm
Sampled signal levels: Paper Break
RED
GREEN
BLUE
IR
Measurement configuration:
Detect filter:
Tx power:
Rx gain:
Set-up
Analog signals: Low limit High limit
Analog output 1:
Analog output 2:
Analog output 3: