ABB M4M 20 - Page 40

40 M4M 20 NETWORK ANALYZER USER MANUAL
Audit log menu
The Audit Log stores an event after an attempt has been made to upgrade the firmware and/or CT ratio,
VT ratio or Type of network is modified.
→ → Unit → Audit log
Each entry contains following data:
Menu Description
System info
Where general information about device from the moment of entry
creation is presented.
Configuration
Where snapshot of CT/VT ratios and Type of network just right after a
successfully performed operation is presented.
Energy
Where value of total imported active energy, imported active energy of
L1-L3 as well as total exported active energy from the moment of entry
creation are presented.
Below you can find the detail of data present for each log entry:
System info
Entry num
Timestamp
Upgrade counter
FW Version
Configuration
TRAFO_V_Prim
TRAFO_V_Sec
TRAFO_I_Prim
TRAFO_I_Sec
TRAFO_IN_Prim
TRAFO_IN_Sec
WIRES
Energy
ACTIVE_ENERGY_IMPORT_TOTAL
ACTIVE_ENERGY_IMPORT_L1
ACTIVE_ENERGY_IMPORT_L2
ACTIVE_ENERGY_IMPORT_L3
ACTIVE_ENERGY_IMPORT_TAR1
ACTIVE_ENERGY_IMPORT_TAR2
ACTIVE_ENERGY_IMPORT_TAR3
ACTIVE_ENERGY_IMPORT_TAR4
ACTIVE_ENERGY_IMPORT_TAR5
ACTIVE_ENERGY_IMPORT_TAR6
ACTIVE_ENERGY_EXPORT_TOTAL