M4M 20 NETWORK ANALYZER USER MANUAL
39
Date/Time menu
During the first commissioning, it is highly recommended to configure the date and time on the network
analyzer (please refer to chapter “7.3.Date and time”).
Brightness menu
In this menu it is possible to modify the display brightness during normal operation conditions.
→
→
Unit
→
Display Brightness
100 %
Brightness
The default value is 100% but it can differ from 10% to 100%.
The lifetime of the graphical display depends on its brightness and stand-by time. It is highly recommended to
limit the brightness level of the display in order to ensure a longer lifetime of the device.
Energy saving menu
In this menu it is possible to define the stand-by time and the stand-by brightness of the display in order
to limit the device power consumption when not in operation conditions.
→
→
Unit
→
Energy saving
Energy saving
Stand-by time
Stand-by brightness
Menu Description
Stand-by time
Set up the time after that the brightness decrease. The default value is 3
minutes but it can differ from 1 to 60 minutes.
Stand-by brightness
Set up the level of brightness when the device is in stand-by. The default
value is 40% but it can differ from 0% to 100%.
The lifetime of the graphical display depends on the brightness of the display. It is highly recommended to limit
the brightness level of the display in order to ensure a longer lifetime of the device.
To Next Page
Loading...
