ABB MB3000 Series User Manual

ESD Warnings Section 2 Safety Summary
4 AA003700-01 rev. G. 2.0
ESD Warnings
Electrical Warnings
Electrostatic Sensitive Device
Perform maintenance procedures in an ESD protected environment.
Always use an ESD protection to perform maintenance procedures on the
MB3000 Series FTIR spectrometer. If you are not familiar with ESD protection,
or if ESD protection material is not available, contact ABB customer support.
Refer to the back cover of this manual.
D
Disconnect power or take precautions to insure that contact with energized parts
is avoided when servicing.
Do not open the spectrometer to perform troubleshooting procedures.
Ensure that the equipment and any devices or power cords connected to MB 3000
FTIR Spectrometer are properly grounded.
The grounding pin of the power connector must be present at all times. If
necessary, have a certified electrician install a grounded wall outlet.
Protective earthing connection (grounding) must be active at all times. The
absence of grounding can lead to a potential shock hazard that could result in
serious personnel injury. If an interruption of the protective earthing connection is
suspected, ensure the equipment is not used.
Always make sure the spectrometer is disconnected from a power source and
fully assembled (front and back panel installed) BEFORE opening or performing
any maintenance.
Always use the Lockout/tag out procedure to power OFF the spectrometer. Refer
to Lockout/Tag Out Procedure on page 10.
Use the spectrometer ONLY if a power outlet properly grounded is available.
Before using the spectrometer, make sure the appropriate line voltage is
available.
Use a power extension ONLY if it has proper conductive protection (grounding).

ABB MB3000 Series Specifications

General

Brand	ABB
Model	MB3000 Series
Category	Laboratory Equipment
Language	English