ABB MB3000 Series - To a Network

To a Network Section 4 Connections
AA003700-01 rev. G. 2.0 18
To a Network
In this setup, both the PC and the instrument will obtain their LAN configuration
from the control DHCP server.
When first turned ON, your spectrometer will attempt to obtain automatically its
LAN configuration from the DHCP server.
To insure your PC Ethernet interface uses the DHCP server, perform the following
procedure:
Figure 4- 1. Connection via a Network
To ensure the DHCP server is properly detected, perform a power OFF/ON cycle
after connecting properly the Ethernet cable (i.e. Network LED must be ON).