Attenuator Location Section 6 Product Overview
28 AA003700-01 rev. G. 2.0
Attenuator Location
Depending on the type of configuration used, the attenuator may be installed on the
MB 3000 series spectrometer at factory before shipment.The attenuator location is
on the left side tower .
Figure 6- 2. Attenuator location
When using accessories that reduce throughput, for example an ATR, a vial
holder, a powder sample, etc., you may remove the attenuator to increase Signal
to Noise Ratio (SNR). The Arid Zone telescopic tube and the attenuator are
screwed on the tower. Refer to Figure 6- 2.
The value indicated on the attenuator is the throughput value, i.e. the amount of
residual energy transmitted.
To Next Page
Loading...
