Installing the Detector Module Section 7 Module Replacement
30 AA003700-01 rev. G. 2.0
Installing the Detector Module
STEP 1 Select the appropriate detector for your needs. The detector type is clearly
indicated on the Detector module.
STEP 2 The Detector module fits tightly into the housing of the Detector module,
gently push the Detector module into place.
STEP 3 Set all 3 captive screws of the Detector module into place. Do not overthighten.
Figure 7- 2. Label location on Detector module
After installing the Detector module, check the LED statuses to make sure the
spectrometer is ready for use. Refer to Table 6- 1. A delay may be required for
temperature stabilization if the detector is T.E.cooled (InAS, InGaAs).
To Next Page
Loading...
