Section 9 Troubleshooting Troubleshooting
AA003700-01 rev. G. 2.0 39
Section 9 Troubleshooting
Troubleshooting
LED troubleshooting table
Do not open the analyzer to perform troubleshooting procedures.
Always use the Lockout/tag out procedure to power OFF the spectrometer. Refer
to Lockout/Tag Out Procedure on page 10.
Each time you perform a step of the flow chart (refer to Table 9- 2) to correct a
situation, reboot the system by closing and restarting the analyzer.
Upon powering up the analyzer, all LEDS should light up for a period of 10
seconds.
To Next Page
Loading...
