Direct Connection Section 4 Connections
AA003700-01 rev. G. 2.0 20
Direct Connection
In this case, both the computer and the spectrometer will use a pre-configured LAN
configuration parameters.
If, when first turned ON, the spectrometer can not detect a DHCP server, it will
automatically use the following IP address:
10.127.127.127
The PC Ethernet interface should be configured to use a compatible set of LAN
parameters, for example:
IP address: 10.127.127.1
Subnet Mask: 255.255.255.0
To ensure your PC Ethernet interface is properly set, perform the following
procedure:
STEP 1 Open Start> Settings> Network and Dial-up Connections.
STEP 2 In the Network Dial-up connections window, right click Local Area
Connection and select Properties. Refer to Figure 4- 2.
STEP 3 In the Properties dialog box, select Internet Protocol (TCP/IP).
Figure 4- 4. Direct connection
To Next Page
Loading...
