Installing the Spectrometer Section 3 Unpacking and Installing
14 AA003700-01 rev. G. 2.0
STEP 1 Connect the Ethernet cable to the computer or to the Network port. Use a
crossover cable for a private connection (spectrometer to computer), and a
straight pin cable for a Network connection (spectrometer to Network).
STEP 2 Connect the Ethernet cable to the spectrometer.
STEP 3 If desired, connect the purge hose to the spectrometer (dry oil-free air or
nitrogen only, recommended 7 l/min.).
Figure 3- 3. Installation procedure: Network connection
To Next Page
Loading...
