PGC5000
PGC5000 Series Service Instructions 8 Replacement parts
SI/PGC5000-EN, Rev B 75
8 Replacement parts
8.1 Ordering information
Since the particular application defines the component parts specific to any given system, please refer to
the “Recommended Spare Parts Lists” in the analyzer’s Data Package to obtain the full and correct part
number for the desired part or assembly.
8.1.1 Equipment identification
Include the following information, found in the Data Package and on the analyzer nameplate, in any communication concerning
replacement parts or components:
• ABB Sales Order Number.
• Analyzer Model Number.
• Analyzer Part Number (P/N) and serial number.
• For serial numbered subassemblies such as PCBs, include the serial number and the part number (including dash
number and revision letter) for the subassembly in the request. If a PCB requires conformal coating, prefix the PCB
part number with the letters "CC."
• Applicable references from the “Recommended Spare Parts List” of the Data Package, included with each analyzer.
• Description of part.
8.1.2 Master controller configuration identification
The Master Controller nameplate (see Figure 8.1) lists the Master Controller configuration information.
To Next Page
Loading...
