6
ABB UPS PRODUCTS AND SOLUTIONS
The PowerValue 11 T G2 is designed, manufactured
and commercialized in accordance with the
EN ISO 9001 standard relating to quality
management systems.
These products conform with the following
directives:
• 2014/35/EU Low voltage directive
• 2014/30/EU Electromagnetic Compatibility
directive (EMC)
• 2011/65/EU Restriction of the use of certain
hazardous substances (RoHS) directive
—
1.3 Declaration of safety conformity and CE marking
WARNING
DO NOT DISCONNECT THE MAINS CABLE
FROM THE UPS OR THE BUILDING WIRING
SOCKET DURING OPERATION AS THIS
REMOVES THE GROUND FROM THE UPS
AND ALL CONNECTED LOADS.
NOTE
PRESS THE OFF BUTTON TO FULLY
DISCONNECT THE UPS. ENSURE THE UPS
IS ON BYPASS OR ON STANDBY MODE
BEFORE DISCONNECTING IT FROM
THE MAINS.
NOTE
TO REDUCE THE RISK OF FIRE, CONNECT THE
UPS TO A CIRCUIT PROVIDED WITH BRANCH
CIRCUIT OVERCURRENT PROTECTION WITH
AN AMPERE RATING IN ACCORDANCE WITH
LOCAL ELECTRICAL CODE.
SEE TECHNICAL SPECIFICATIONS
FOR RECOMMENDATIONS.
WARNING
INDISCRIMINATE OPERATION OF
SWITCHES MAY CAUSE OUTPUT
LOSS OR DAMAGE TO EQUIPMENT.
WARNING
NEVER DISPOSE OF BATTERIES IN A FIRE
AS THEY MAY EXPLODE.
WARNING
DO NOT OPEN OR DAMAGE THE
BATTERIES.
WARNING
RELEASED ELECTROLYTE IS HARMFUL TO
THE SKIN AND EYES.
—
1.5 Operation
ABB or authorized agent. The serial number is
shown on the nameplate of the product.
For further information on troubleshooting,
see Chapter 6.
Inquiries regarding the UPS should be addressed
to the local ABB office or agent authorized
by ABB. Note the type code and the serial
number of the equipment before contacting
—
1.4 Inquiries
These products also meet the following product
standards:
—
Table 1: Standards
Product Standards
Safety
EMC
Performance
ESD
Radiated field
EFT
Fast transients
Electromagnetic field
Conducted magnetic field
RoHS
To Next Page
Loading...
Need help?
General