ABB PowerValue 11 T G2 Series User Manual

10
ABB UPS PRODUCTS AND SOLUTIONS
3.2.1 Planning before the installation
To ensure a long service life, install the unit
in a position where any danger to the UPS is
minimized:
• Install the UPS indoors.
• Leave 50 cm of space on each side of the
cabinet to allow cooling airflow and ensure
that the circulation of air to the ventilation
slits is not obstructed.
• Avoid excessively high temperatures and
excessive moisture.
• Make sure that the surface is solid and flat.
3.2.2 Positioning
PowerValue 11 T G2 can only be installed in a
standalone configuration.
WARNING
WATER CONDENSATION MAY OCCUR IF
THE UPS IS UNPACKED IN A VERY LOW
TEMPERATURE. TO AVOID HAZARDS AND
RISK OF ELECTRIC SHOCK, WAIT UNTIL
THE UPS IS FULLY DRY BOTH INSIDE AND
OUTSIDE BEFORE INSTALLING/USING
THE UPS.
3.2.3 Standalone / tower installation
3.2.3.1 UPS
1. Place the unit on a flat, stable surface in its
final location.
2. Install ‘Stabilizer bracket’(optional): remove
side’s screw from the unit, then install
‘Stabilizer bracket’ to the unit.(figure 1).
3. Install the unit to a surface(optional): place
4pcs bolts(M8 is recommended) to the final
location previously, bolt’s position please
refer to below, then fix the unit to the bolts.
—
3.2 Site planning and positioning
—
02
—
01 Stabilizer brackets
preparation
—
02 Stabilizer brackets
installation
—
01

ABB PowerValue 11 T G2 Series Specifications

General

Brand	ABB
Model	PowerValue 11 T G2 Series
Category	UPS
Language	English