Parameters 37
Parameters
Contents of this chapter
The chapter describes the inverter parameters. The parameters are either editable or
read-only. The parameters can be used to change inverter settings and are saved
periodically to permanent memory.
The read-only parameters (actual values) can be used to view the inverter status. An
actual value is the result of a measurement or calculation by the inverter, or it contains
status information.
Compatibility
The parameters described in this section are compatible with firmware version KLUF0
v1.72.
Earlier firmware releases does not support all parameters described in this document. If a
parameter is not visible when using the control unit or the Drive composer configuration
tool, then that particular parameter or feature is not supported in the firmware version that
the inverter is currently running.
To Next Page
