FEP630, FEH630 ELECTROMAGNETIC FLOWMETER | CI/FEP630/FEH630-EN REV. D 53
Zero point adjustment of the flowmeter
Note
Prior to starting the zero point adjustment, make sure that:
• There is no flow through the sensor (close all valves, shut-
off devices etc.)
• The sensor is completely filled with the medium to be
measured
Easy Setup
System Zero
Next O
• Use to start automatic adjustment of the zero point for
the system.
Menu
Easy Setup
Exit Select
Once all parameter have been set, the main menu appears again.
The most important parameters are now set.
40.Use to switch to the process display.
Change from two to one column
To Next Page
Loading...
