102 Product manual - PVS-175-TL;A.1 Version
EN
STEP 2 (Optional) - Wireless network connection.
As described on “Ethernet connection” paragraph the recommended way to get all the installed inverters
communicating to the internet and Aurora Vision Cloud is creating a wired Ethernet daisy chain bus.
Anyway, in case of a few inverters installation in suitable environment, it is also possible to connect each
inverter of the plant to a Wi-Fi router without using any cable.
Aurora Vision Plant Viewer™
Aurora Vision Plant Viewer for Mobile™
Aurora Vision Plant Portfolio Manager™
Customer SSID
IP given by router
DHCP server
IP given by router
DHCP server
Direct Access
SSID: ABB-XX-XX-XX-XX-XX-XX
(XX-XX-XX-XX-XX-XX= Inverter MAC address)
PVS-120.0
- The AP is still available and the user can
connect to the inverter.
- In this scenario the Router gives IPs
according to its own rules.
- Inverter is reachable by IP.
- Domain name can be used only if the
Router permits multicast
During the installation wizard, the installer will be asked to connect the inverter to a Wi-Fi router. By
selecting connection to Wi-Fi router the inverter will turn on a second Wi-Fi radio channel in order to
enable connection to the Wi-Fi router.
NOTE – D By selecting “Skip this step” button the second radio channel will be kept off and you
will need to use a wired Ethernet daisy chain bus to allow the inverters to communicate.
Two Wi-Fi radio channels enables simultaneous wireless connection; one static IP address connection
between inverter and installer devices and one between inverter and switch/router.
NOTE – D Whatever option is used to connect the inverter to the switch/router (Ethernet cable
or Wi-Fi) it will be always possible to access to the Web User Interface by connecting its own
device (Smartphone, tablet or laptop) to the same switch/router, and reaching the inverter by
using the assigned IP address or inverter’s host name.
NOTE – D The IP address assigned to the inverter may vary or may be unknown. Please contact
the IT administrator for getting the assigned IP address.
NOTE – D Differently from the assigned IP address, the «Host Name» of the inverter is does not
change over time.
NOTE – D In order to use the «Host Name» as an alternative to the assigned IP address, for
accessing to the inverters Web User Interface from the router, the Domain Name System (DNS)
service shall be available and activated.
NOTE – D The Host Name associated to each ABB inverter is structured as indicated below:
ABB-logger ID.LOCAL
where logger ID stands for the MAC address indicated on the “Communication identification
lable” applied on the inverter.
To Next Page
Loading...
Need help?
General