ABB RELION REX640 - Page 109

1. In Signal Grouping Editor dialog, select a group from the Signal Group
drop-down list.
2. Click Remove.
GUID-3A045F5E-96D8-485B-ADC4-20D8F530AB8C V1 EN
Figure 78: Removing a signal group
Adding and removing signals
• Add new signals.
1. In Signal Grouping Editor dialog, select a group from the Signal Group
drop-down list.
2. In List of All Signals list, select the required signals and click .
Add seven signals at the maximum to a single group.
3. Click OK.
1MRS759117 A Section 6
LHMI engineering
REX640 101
Engineering Manual