Quick start-up guide
19
Quick start-up guide
Overview
This chapter presents the steps to take during the start-up of the
RETA-01 Ethernet Adapter module. For more detailed information,
see chapters Mechanical installation, Electrical installation,
Network configuration, Drive configuration, and Communication
elsewhere in this manual.
WARNING! Follow the safety instructions given in this manual and
the Hardware Manual of the drive.
Preliminary preparation
• Before installation of the module, write down the MAC ID of the
module (Printed on a sticker on the back of the module)
• Make sure you have the two screws for fastening the module
Mechanical installation
• Insert the RETA-01 into its specified slot in the drive (SLOT2 for
ACS550, SLOT1 for ACS800).
• Fasten the two screws.
Electrical installation
• Connect the Ethernet cable (RJ-45 connector) to the RETA-01
module. Standard CAT 5 UTP or STP cables can be used.
Avoid parallel runs with power (e.g. motor) cables.
Drive configuration
• Power up the drive. The “MODULE STATUS” LED should be
green. If the network cable is connected to an active network,
the green “LINK/ACTIVITY” LED should also be lit or blinking.
To Next Page
Loading...
